beam adjusters
Moderator: Ken
2 posts
• Page 1 of 1
beam adjusters
by staggerwing » 01 Wed Nov, 2006 12:20 pm
Installing beam adjusters tomorrow and was wondering if one can remove the torsion bars as an assembly on each end of the beam without having to mess with (disturb) the ball joints. Any other suggestions are certainly welcome!
-
staggerwing - Buggyholic
- Posts: 641
- Joined: 16 Fri Jun, 2006 10:54 am
- Location: Seguin, TX.
by David O' » 01 Wed Nov, 2006 1:52 pm
You ned to get the arms off of the beam before you start the adjusters. The torsion bars have to come out of the beam before you start welding!
If your ball joints are good, and you rip the boots getting them loose, I've got ball joint boots in stock up here! (yea, I actually have JUST the boots for ball joints)
If your ball joints are good, and you rip the boots getting them loose, I've got ball joint boots in stock up here! (yea, I actually have JUST the boots for ball joints)
If at first you don't succeed, beat the pshaw out of the business partner, and then go at it alone! LOL!
- David O'
- Buggyholic
- Posts: 391
- Joined: 01 Sat Oct, 2005 11:10 am
- Location: Dallas, Texas
2 posts
• Page 1 of 1
Who is online
Users browsing this forum: No registered users and 35 guests