while refinishing the ghia motor I pulled out the dizzy
then went about my buisnes as usual
when I went to put it back in it dident fit
yes I turned the crank with out the dissy inside
after a bout 1/4 turn it got hard to turn but I insisted on turrning
like I always do
I heard something sorta like a bolt falling down inside the engine I dont Know what it could have been I dident drop a bolt in Im sure of that
at this time I stoped and went to the book
the book says NOT to do this!!!!! oh great now you tell me
and if you do you need to pull the fuel pump rod witch I dident do
while trying to round it around to number one is there something under the dizzy drive shaft I missd
some thing broke Im just not sure what just yet
I am going to borrow a drive shaft puller tomorrow to pull it out and check the cam shaft gear and go back to #1 to try and install
the dizzy again
any help would be apreciated
blackthree4me