So there I am with my project buggy in parts, and while I'm poking around, I peer throught the starter opening in the tranny, and realize I'm sans flywheel!
No biggie right!
But I do have a few questions:
*If I buy a flywheel with 8 pins, will it work with a stock 4 pin crank shaft?
*In addtion to the flywheel purchase I will need
*Gland nut and washer?
* 4 pins?
*Flywheel shims? and how does one determine the proper application of the shims?
I'll also put in a new clutch, plate and throw out bearing, but what else?
Thank,
Mark