Maximum width of front seats...

[Greaph]

What is the maximum width of the front seats at the base in the standard manx clone? I know this is a somewhat general question, but I am not at home where I can measure this :-(.

I.E.- the measurement from the center tunnel to the side wall.

Thanks !!

[matter396]

19inches. Some guys say they can get 20 or 21 but they have to space them up. Really 19 is the perfect fit.

[DannyT]

Anyone have any ideas what production cars might have these in them. Wife wants to pick out the fronts and have the back sewn up to match.

[Texasbuggys]

never thought about it until just now has anybody looked at the new smart car seats?

[Jack Duncan]

Greaph, I ordered mine today. I will use the Pro90 seat. Have a look at the seat.
www.procarbyscat.com
If I have to I'll raise them up a little, but I don't think I'll have to. I have a Bandit and it might be just a little wider. It measures 21'' from the tunnel to the body.

[Greaph]

Thanks for the replies. I REALLY wanted to use the Beard RX-1's, but they are just 3" too wide. After talking to Brad at Redart.com, I decided to use the Ultra Pro's. Anyone else use this seat style? I ordered them with the shoulder loops, so i can install both traditional lap and shoulder belts for everyday driving, and 5-point camlocks for driving of a more aggressive nature.

[Bill K]

'95 Ponitiac Sunfire buckets will fit.

[Texasbuggys]

Bill who covered yours?

[Bill K]

Intitally, a shop in Columbus covered them, but they did such a bad job that I had to have them redone. A shop here in Rosenberg did them for me. It is called Juarado's Upholstery & Trim. (Lupe @ 281-342-5163).